Today I will share with you how to open the port (Nat port) of TP-Link ER6120 VPN Gigabit Omadaand similar lines
Contents
Step 1: Log in to Router ER6120 and proceed to Nat Port
- Sign in to your modem by opening a web browser and typing http://192.168.0.1 (default or optional). It will appear the router’s interface and ask to log in.
- Go to Transmission -> NAT -> Virtual Servers -> Add
Step 2: Enter the parameters to nat port
- Name: As you please, set
- Interface: WAN
- External Port: The external port needs to be open for the signal to enter. This example is port: 37777
- Internal Port: The internal port of the device that needs NAT out. This example is port: 37777
- Device IP Address: enter the IP address to be NAT, This example NAT port of Camera has IP: 192.168.0.144
- Protocol: ALL
- Check Enable
- Then click OK to save the open port configuration
Step 3: Check port opening results
- By going to the following ping.eu page, select Port Check.
![](https://cctvapp.net/wp-content/uploads/2021/06/5-1156509j17715.png)
- The browser will redirect to another page where you do the following:
![](https://cctvapp.net/wp-content/uploads/2021/06/6-1156511j17715.png)
- Click on the number after the words Your IP is
- In the IP address or host name box, that number will appear
- In the Port Number box, enter the ports you have opened. click Go.
- If the result as shown above is that you have succeeded On the contrary, as shown below, you have not succeeded, it is necessary to check the steps above.
![](https://cctvapp.net/wp-content/uploads/2021/06/7-1156512j17715.png)
Thank you for following cctvit.net article!